Preparation and Application of Concrete Clear Sealer
Mary Ann
How do you apply the clear sealer on your concrete floor? What are the necessary preparations needed to use it? What makes the clear sealer a viable solution for old and cracked concrete floors? How easy is it to use concrete sealers? These are just some of the questions that an ordinary homeowner might be asking when looking for concrete coatings. And where concrete coatings are concerned, a clear sealer is always present.
A concrete clear sealer is an acrylic solution that dries up to make a colorless and clear film over your concrete floor. You can apply it on any concrete surface --- in driveways, garages, pool decks, and walls. It can be used inside the home or building as long as the room is well-ventilated to eliminate the slight smell of the solution.
The concrete clear sealer is resistant to stain , acid, oil, and other chemicals. Other advantages of a concrete clear sealer is that it is ultraviolet resistant as well as abrasion resistant. So not only does it give a new and fresh look to your concrete when you're finished, it also protects the concrete from any damages from chemicals and hard impact.
Preparing to use and apply the concrete sealer on your concrete requires some hard work and patience. Surfaces with cracks and holes must be filled and patched first. The concrete surface must be solid before you get to apply the clear sealer.
The concrete surface has to be clean and devoid of dirt or other substances that could affect adhesion. For nonporous surfaces, it is recommended that the owner clean it with muriatic acid, which is rinsed thoroughly afterwards.
Get every help you can get in your cleanup phase before applying the clear sealer. Household cleaning products such as a stiff broom, a garden hose, and bleach and de-greaser will do well. Basically you need to de-grease the surface and remove oil stains. Next, you remove any mold or mildew in the concrete. The concrete has to be entirely clean or any alien substances. Lastly, for this preparation, use a stick broom to remove any residues that were left over.
Remember to wear protective goggles when preparing and applying the concrete clear sealer. You should also wear gloves and some protective clothing. The mixture may not be harmless to your skin and may cause itchiness or rashes. Also remember not to add detergents or ammonia to the bleach and water solution for a better cleanup.
When applying the clear sealer, make sure you stir it well, both before and during applying it to the concrete surface. Bear in mind that you should only apply it when the surface and air temperatures are above 40ﾰF. It is also best if you apply it on a temperature that doesn't exceed 90ﾰF because this will cause premature drying with bubbles forming from trapped vapors.
Use an airless sprayer when applying the concrete clear sealer. You can also use a cure roller or plain brush. But do not use a hand sprayer. One important thing to remember when using a clear sealer it to stay far from open flames and sparks. After using it, make sure you seal the clear sealer tightly.
The preparation and application of a concrete clear sealer to your concrete surface is fairly easy when you've understood the instructions. All it needs to finish the job is work and patience in doing it.
|
